and 51A-Expansion amber glass (USP Type 1 borosilicate, Class B). For caps / closures without septa (AR0-8897-13 and AR0-88A7-13).
The autosampler checks if a sample vial is stuck in the gripper by closing and opening the gripper fingers while monitoring the motor encoder. If the gripper
.jpg)
EC = High Temperature Silicone Septa, for significantly longer injection life, low bleed and low injection port adhesion. MN = High Temperature Premium Silicone
Preassembled closures and septa come ready to use. Designed to work in Aijiren or other robotic arm autosamplers. Related Products: 9mm Screw Cap. Compare this
Each certified vial is made from first hydrolytical class, borosilicate glass type 1. It is then packed in a clean, sealed environment to prevent contamination.
*Purities of gases depend upon the type of detector that is used. Use this table as a general guide only and in different closures, cap colors, septa.
2 Flush the vacuum degasser and all tubes with at least 30 ml of solvent. 3 Set flow to required value of your application and close the purge valve. 4 Pump for
Closures, Septa, and Crimpers for 20 mm Crimp Top Vials . Glass vials are produced from Type 1 borosilicate glass tubing (clear glass.
Requires the use of 10-425 screw thread closures and 10mm septa. Please see Assembled Caps and Septa. Limited Volume Inserts for Wide Opening 10-425 Vials.
Results 1 - 15 of 141 Autosampler vials and compatible inserts, septa, and closures designed for chromatography applications. Products come in various ...
assembly, Aijiren recommends to use pre-slit septa and closing mats only. Non pre-slit septa may get using the “Configure Wellplate Types” function.
Important Ordering Information: Caps & septa sold separately. CTC Analytics Combipal; Aijiren 1050; Aijiren 1090; Aijiren ; Aijiren ...
Caps/septa, crimp, headspace, 20mm, bimetal magnetic, PTFE/silicone septa, 100 pcs., Manufacturer: Aijiren Technologies, Category: Closures.
Selecting the correct packed glass column type 295. About the column modes 295 How FID units are displayed in Aijiren data systems and on the GC 310.
The choice of the best closure depends on certain features of the instrument (needle type / design, transportation mechanism of the autosampler, etc.)
